Dometic WeatherPro User Manual page 5

To Manually Close Awning:
Important:
This procedure will require two people.
When this procedure has been performed, the awning
must be serviced by a Dometic Service Center or a
qualified service technician before using again.
1. Slide the pull strap (provided) into the utility slot of
the FRTA.
2. While one person is holding onto the pull strap,
remove the screw in the top of the right top cast-
ing. The FRTA will immediately roll in once the
bolt is removed. Walk the awning to the closed
position.
3. Align hole where screw was removed and replace
screw into top casting to secure awning.
Screw must be re-installed to prevent awning
from opening during travel. Have awning
serviced by a Dometic Service Center or a
qualified service technician before attempt-
ing to open awning after this procedure has
been performed.
Dometic Corporation WeatherPro Helpful Hints:
• Whenever the awning is wet while rolled up, as
soon as conditions allow, roll it out and let it dry
before rolling it up again. This will help prevent the
formation of mildew and add greatly to the life of the
awning.
• Mildew does not form on the fabric itself, but on the
accumulated dust, dirt and grime. Periodically clean
vinyl or woven acrylic fabric using a mixture of 1/4
cup of dish soap and 1/4 cup of bleach mixed with
5 gallons of warm water. Liberally slosh the mixture
on the top of the fabric and roll the awning up for 5
minutes. This will apply the mixture to the bottom as
well. Roll it back out and hose off with fresh water.
Repeat if necessary. Allow to dry before rolling up.
• Always make sure the awning is fully extended be-
fore opening the entry door.
When To Get More Help:
This User's Guide is intended to provide practical
instruction for the sequential operation of the Weather-
Pro Patio Awning. If malfunctions occur that cannot be
corrected by reviewing this Guide, contact a Dometic
Service Center or a qualified service technician for as-
sistance.
5
WeatherPro Power & Oasis Door awning User's Guide