1. Manuals
  2. Brands
  3. Allo RemoteControl Manuals
  4. Receiver
  5. NICE HSRE12
  6. Instructions

Allo RemoteControl NICE HSRE12 Instructions

Hide thumbs
1
2
3

Advertisement

Table of Contents

INSTRUCTIONS
NICE HSRE12
To enable the control devices to activate the outputs of HSRE12, the device codes
must be memorised on the receiver.

Memorising devices on the HSRE12 receiver:

To memorise a device, proceed as follows:
01.Press S1 (PROG) to activate programming mode; a BEEP indicates the start of
programming;
02. Select the required output by pressing S2 repeatedly (SEL.CAN); the relative led
of the ALL output illuminates;
03. Memorise one or more devices for each output, performing the action specified in
Table 1;
Visit our Website. www.alloremotecontrol.com
04. A BEEP confirms correct programming, 3 BEEPS indicate that the device has
already been memorised;
05. To memorise other devices on other outputs, repeat points 02 and 03;
06. The memorisation phase terminates by pressing S1 and S2 simultaneously or after
1 minute of inactivity.
Caution! It is not possible to memorise devices with a timed function
together with devices with an ON-OFF function on the same output.
Visit our website: www.Alloremotecontrol.com
families:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NICE HSRE12 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Allo RemoteControl NICE HSRE12

Summary of Contents for Allo RemoteControl NICE HSRE12

  • Page 1 INSTRUCTIONS NICE HSRE12 To enable the control devices to activate the outputs of HSRE12, the device codes must be memorised on the receiver. Memorising devices on the HSRE12 receiver: To memorise a device, proceed as follows: 01.Press S1 (PROG) to activate programming mode; a BEEP indicates the start of programming;...
  • Page 2 Output function selection: During memorisation of the devices, activation of the alarm can be programmed in the case of an alarm to do this, proceed as follows: 01. Select the required output by pressing S2 repeatedly (SEL.CAN); the relative led of the ALL output illuminates;...
  • Page 3 Deleting all devices memorised on all outputs of HSRE12 To delete all memorised devices, proceed as follows: 01.Press and hold key S1, then power up; 02. Wait for 10 seconds, keeping key S1 pressed; a BEEP confirms deletion of the devices; 03.

Table of Contents