1. Manuals
  2. Brands
  3. Allo RemoteControl Manuals
  4. Receiver
  5. NICE OX4T
  6. Instructions

Allo RemoteControl NICE OX4T Instructions

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

INSTRUCTIONS
NICE OX4T Receiver
Warnings:
Some programming functions in this chapter use the key P1 and led L1 (fig.
3-G/H) of the receiver.
During programming the led emits a specific number of flashes, with a specific
duration and colour (green, red or orange) to indicate the current operating status.
For the meaning of these signals, consult Table B at the end of the manual. Other
functions can be programmed exclusively using the devices Obox or Oview belonging
to the NiceOpera system
Visit our Website. www.alloremotecontrol.com
Visit our website: www.Alloremotecontrol.com
families:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NICE OX4T and is the answer not in the manual?

Questions and answers

Related Manuals for Allo RemoteControl NICE OX4T

Summary of Contents for Allo RemoteControl NICE OX4T

  • Page 1 INSTRUCTIONS NICE OX4T Receiver Warnings: Some programming functions in this chapter use the key P1 and led L1 (fig. 3-G/H) of the receiver. During programming the led emits a specific number of flashes, with a specific duration and colour (green, red or orange) to indicate the current operating status.
  • Page 2 MEMORISATION OF TRANSMITTERS: The receiver can memorise up to 1024 transmitters. Compatible with radio encoding “O- Code” / “FloR” / “TTS”, or “Smilo”, or “Flo”. Caution! – These three encoding groups are not compatible with one another; therefore the first transmitter memorised in the transmitter also defines the encoding family for all the subsequent transmitters.
  • Page 3 MEMORISING A NEW TRANSMITTER USING THE PROCEDURE “IN THE VICINITY OF THE RECEIVER” [requires a transmitter already memorised] The procedure must be performed within the reception range of the receiver (maximum 10- 20 m from receiver). • If the OLD transmitter is memorised in “Mode I” during the procedure press any key either on the Old or New transmitter;...
  • Page 4 Alternative procedure: 1. On the NEW transmitter, press and hold the key *** for at least 3 seconds and then release. 2. On the OLD transmitter, press and hold the key *** for at least 3 seconds and then release. 3.

Table of Contents