Table of Contents
Advertisement
C10325A
v2.2, C10325B V2.2
High efficiency wide input voltage
PFC programmable Charger
90V~265VAC input
For 4S~24S LiPo/LiFe battery
1~25Amps 1500W max.
Total solution on E-Vehicle application
Chargery BMS is a successful combination with the charger. When all cell voltage reach setup value, the
BMS will communicate with the charger, the charger will continue to charge at a smaller current rather
than stopping charging.
It is very important at large current charge application. Because Start and Stop charge repeat by Close
or Open relay or MOSFET, NOT only cause battery voltage fluctuation at a large range, shorten
mechanical switch or electronic switch life, but also extend charging time notably.
Chargery BMS and charger as a total solution can charge and monitor each cell voltage, temperature,
charge and discharge current, short circuit even cell voltage difference, and charge each cell to any
voltage you want, such as you can set up the charge terminal voltage 3.85V per LiPo cell, when charge
is done, the battery pack will be storage at safe status,
NOTE
Chargery charger decrease charge current according to "Over Charge Protection (P) Voltage" on BMS
setup, so please setup the charge terminal voltage in accordance with Over Charge Protection (P)
Voltage on BMS.
14
19
www.chargery.com
page
total
Advertisement
Table of Contents
