Table of Contents
Advertisement
Program Setup
1. In charger idle interface, press
into Program Setup menu.
2. LCD display the following information in sequence and you can
modify its value. When you want to alter a parameter value, press
the
knob
button make the value blink then modify the value by
rotate the button. The new value will be confirmed and saved by
pressing the button again.
3. Press
knob
quit the setup menu.
Max current
--->
60A
Fan ON Temp.
--->
40℃
Shut Down Temp.
--->
80℃
Buzzer
--->
ON
BACK-LIGHT TIME
--->
5MIN
Temp. Unit
--->
℃
Note:
All parameters will be remembered by the C10325A/B till next change.
C10325A
knob
button for 2 seconds enter
Setup the maximal charge current, range from 1A~25A, step 0.1A, default
25A. It is only active for power supply.
Setup the fan starting temperature, range from 30~50℃, step 1℃,
default 35℃. The fan speed will increase with the temperature go
up.
Setup over temperature protection, range from 70~110℃, step 1℃,
default 110℃. Over the temperature, the charger will power off
The beeper sounds for each button press to confirm your action. These
sounds can be ON or OFF. Default ON.
This menu sets the back-light time of LCD screen backlight.
Options: 1MIN, 5MIN, 10MIN, 20MIN and Always on, default 5MIN. At
default 5min, LCD back-light will be off to save the power, press
resume the back-light.
Setup the Temperature unit,
www.chargery.com
v2.2, C10325B V2.2
High efficiency wide input voltage
PFC programmable Charger
For 4S~24S LiPo/LiFe battery
1~25Amps 1500W max.
Picture 3
℃ or ℉,
default
℃
.
page
90V~265VAC input
Program setup
knob
10
19
total
Advertisement
Table of Contents
