TCT Mobile GIN One Touch 918 Repair Document page 17

GIN/One Touch 918(N/A/D/S) L2 repair document
Switch on with battery
power
Main display
Keyboard
Vibrator
Network Problem
TF card
Camera
Audio
In case the LEVEL 2 repairs can‟t solve the problem, or if the board is damaged, exchange the board.
6. BOARD EXCHANGE
In case that LEVEL 2 repair does not solve the failure, it is mandatory to change the board and apply the
following process:
1) Collect the fault PCBA board (without accessories LCD, and camera), with microphone and vibrator.
2) Get a new PCBA from swap stock. Reuse those accessories to assemble the mobile.
3) Fill in the fault sticker with IMEI number, the fault code, the short code, the Hardware Technical Level, and
the software version.
4) Send the fault PCBA with fault sticker back to L3 repair center with the suggested packaging method, the
detail packaging method please see solution 1 of APPENDIX 2.
7. OTHER COMPONENT EXCHANGE
The other components exchange like LCD module,vibrator, receiver, speaker, microphone, camera, FPC
connection, audio/camera connector and related mechanical components, please follow the detail steps from
paragraph 7(Disassembly and Reassembly process), but need to be very careful to handle the components with
related special tool or jig (especially replacing new components) and better to handle it with plastic tools
ED 1.0
All right reserved. Passing on and copying of this document, use and communication are not permitted
without authorization
By NCK Team
Can „t Switch on
Missing line or column; no
display; bad or no LCD
backlight
Keyboard backlight or
keyboard function
The vibrator does not work
No emission or No reception
No communication between
the phone and the TF card
Camera doesn't work
Bad or no emission (TX audio
from mobile);
Bad or no reception (RX audio
on mobile);
Hands-free problem;
Key beep and melody
problem
GIN Level 2 Repair Document
2.Check the battery connection, change
the battery connector if broken;
3.Check the charge plug, change it if
necessary;
1.Check voltage of the battery;
2.Check the battery contact, change the
battery connector if broken;
3.Check the keypad
4.Check BTB connector socket pin
Check Connection flex (FPC
cable),change it if necessary;
Replace display module if necessary;
Check keypad film or keypad PCB,
change it if necessary
Check the contact on the PCBA (dirty or
oxidized), replace the vibrator if necessary;
Check the antenna contactor on the
PCBA;
Check the contact on the PCBA (dirty or
oxidized);
Check the TF connector on the PCBA;
Check camera module
Check also camera FPC broken or not
Check microphone, replace it if
necessary;
Check the contact on the PCBA (dirty or
oxidized)
Check loud speaker, replace it if
necessary;
Check the contact on the PCBA (dirty or
oxidized)
21/27