Table of Contents
Advertisement
Available languages
Available languages
6
NOTE: Units do not have to be clicked tightly together to function. As long as
the male end is plugged into the female end, the units will be powered on. (See
Figure B)
WARNING: Your system was designed to connect only with other Oster
units. Do not attempt to plug in any other appliances other than those that are sold
within this system.
6.
To add additional units, repeat steps 3-5.
7.
Add your ingredients to the Stoneware of each unit and cover with the Glass Lid(s).
8.
Select the temperature setting (HIGH "ALTO", LOW "BAJO" or WARM
"CALENTAR") for each unit based on your recipe. The Indicator Light on
each unit will illuminate, indicating that your units are on.
NOTE: WARM is only for keeping already-cooked food warm. Do not cook on
the WARM setting.
9.
When finished using, turn off and unplug the first unit that is plugged into the electrical
outlet and allow units to cool down prior to cleaning.
WARNING: Do not attempt to lift multiple units at one time when they are
connected together.
10. Once the units have cooled down, separate and pull the system apart using
the integrated handles on the bottom left and right-hand sides of each unit.
11. Once the unit has cooled, store the cord by slowly feeding the cord back into
the base until it clicks into place.
FUSE/OVERLOAD PROTECTION:
Your system is designed to prevent connecting more than the recommended
number of units (six) to each other. When using multiple units together, and when
necessary, any unit that overloaded the system will turn itself off.
NOTE: Recommended maximum number of units to plug in to one outlet is six (6).
This may vary depending on circuit.
•
Depending on the circuit, you may need to remove one or more units from
your system so the circuit does not trip again from overload.
If this happens, simply reset the built in Resettable Circuit Breaker on the
•
unit that is plugged directly into the wall. To reset the unit, push the resettable
button with your index finger as shown:
•
Additionally, you may have to reset all the subsequent units that are
connected after the tripped unit that overloaded the system.
You will notice which units have turned themselves off, as the Indicator
•
Light will no longer be illuminated on these units.
5
4
En glis h-7
3
2
Figure B
Figure A
1
Hook Up
®
Advertisement
Table of Contents
