Advertisement
Encryption type and key will need to be obtained from your
wireless router's administration web page. Please see the
instructions of your router to obtain this.
Note your network information here before installing the WiFi
B- -SAM.
SSID
Encryption Type:
Encryption Key:
1. Mount WiFi B- -SAM and connect ABC wiring and 24VAC
transformer.
2. Power up WiFi B- -SAM and HVAC system and perform in-
stallation procedure from user interface.
Go to Installer Service menus (10 second press of
Advanced) and select INSTALL.
Ensure "REMOTE ACCESS
equipment summary screen (check ABC wiring if not).
3. Go to the WiFi B- -SAM Setup screens by pressing the Ad-
vanced button on the user interface and then pressing the
right side button until the WiFi B- -SAM Setup screens ap-
pear. These screens will not appear if you do not have a - -B
model user interface.
4. Press the right side button to get to WiFi B- -SAM
WIRELESS SETUP 1.
5. Highlight the SSID item and enter your network's SSID (it
is case sensitive).
Press the Temp Up/Down to move the cursor left or right.
Press the Time Up/Down to change the character.
SSID of a network, note the name of your network (including case of letters)
YES" appears on
The Space character is obtained by continuously pressing
the Time Down button.
6. If you have encryption, press the right side button to go to
WiFi B- -SAM WIRELESS SETUP 2.
Select the encryption type.
Enter the encryption key.
Press the Temp Up/Down to move the cursor left or
right.
Press the Time Up/Down to change the character.
Encryption type and key will need to be obtained from
your wireless router's administration web page. Please
see the instructions of your router to obtain this.
7. Exit the menus by pressing the Advanced button, saving all
entries.
8. Give the system about 2 minutes to respond to all the
changes.
9. The green LED light on the WiFi B- -SAM wireless circuit
board will flash if it is NOT connected. The LED will be lit
solid if it is connected to your network.
10. If the LED is lit solid, give the system 15 minutes to trans-
mit your equipment information to the server. Then, go to
the web site and register your system by clicking on New
User link. Enter your WiFi B- -SAM's serial number and
MAC Address.
11. If the LED continues to blink, check your SSID and encryp-
tion entry for errors.
2
A08410
Advertisement
