Installation - KNOVA KN INW-160 Manual

TECHNICAL DESCRIPTION
Fuse
A
Amperage
V
Voltage
3
Thee phase

INSTALLATION

Installation Diagram
WARNING
It is forbidden to connect
the workpiece to the welder with iron
or other poor conductors.
Positive earth
Line
1
Single phase
X
Duty cycle
Welding torch
SMAW
GTAW
Wire feed
function
Connection
• The welder should be placed in dry and dusty
surrounding where there is no corrosive chemicals,
flammable, explosive gases.
• Avoid direct sunlight and rain. And maintain the ambient
temperature ranging from -10º C to 40º C.
• The space of 50 cm should be left around the equipment.
• If indoor ventilation is not good enough, the ventilation
exhaust device should be installed.
Power Source Connection
Access the back panel (power source cable) to the power
supply which is equipped with circuit breakers and grounding
line (grid), and it is strictly prohibited that ground wire is
connected to the grid, otherwise bear your own
consequences.
Electrode Polarity (see above picture)
Connect the quick plug with electrode holder to the positive
terminal and then tightened them up clockwise.
Workpiece Connection
Connect the quick plug with earth clamp to the negative
terminal on the front panel below. And then tighten them up.
Access the earth clamp to the workpiece.
3
GMAW
High
Temperature
Welding gun
Grounding cable
Work piece