Starrett S-700 Series Installation Manual

S E R I E S S - 7 0 0

I N S TA L L AT I O N

We recommend that your door is

installed by a recognised Spitfire Partner.

Key Points:

1. If you are replacing an existing door, please measure

the new door to make sure it fits before removing

the old door and make sure that the threshold height

and or cill and packers allow enough clearance to

open the new door when fitted.

2. Please store your new door in a clean and obstacle

free area before installing

3. Make sure the aperture is level and as plumb as

possible before starting to install

REMEMBER – A SINGLE S-700 SERIES DOOR

WILL WEIGH AT LEAST 120KG AND IS A

MULTIPLE PERSON LIFT!

If you think anything is missing, or

there is damage, alert Spitfire Doors

or your supplier immediately.

sales@spitfiredoors.co.uk

G U I D E

M A K E

G R A N D

E N T R A N C E

Table of Contents

Do you have a question about the S-700 Series and is the answer not in the manual?

Page 1 3. Make sure the aperture is level and as plumb as possible before starting to install REMEMBER – A SINGLE S-700 SERIES DOOR WILL WEIGH AT LEAST 120KG AND IS A MULTIPLE PERSON LIFT! If you think anything is missing, or there is damage, alert Spitfire Doors or your supplier immediately.
Page 2 Installation Preparation SUGGESTED TOOLS REQUIRED Installing an S-700 door, requires 3-4 people to lift the door into place and to hold it in position whilst adjusting, 1. 1.8m Spirit level during installation. 2. 0.6m Spirit level Carefully unwrap your S-700 pivot door and dispose of the 3.
Page 3 Installation Determine the finished floor level of your building because your Spitfire Series 700 threshold sits at floor level. There is only 25mm of cover between the bottom of the door sash and the threshold. Unlock your door and open it to 90 degrees. On the inside of the frame, you will see the slotted top pin retracting screw.
Page 4 Installation When the door is slotted into the baseplate, you will need to sink the top pin back into the door sash to secure it in place. - Removing the top outside gasket will give you better visibility of the top pin. (Image 5) - Bring the top pin in line with the opening on the sash and screw the top pin into place until the top pin retracting screw is fully wound back into place (Image 6)