Craftsman CMEPW2100 Instruction Manual page 8

English
Attaching High Pressure Hose (Fig. I- K)
NOTICE: Never pull water supply hose to move
pressure washer. This could damage hose and/or
pump inlet.
1. To connect the high pressure hose
handle 3 , screw the hose collar
coupler 42 .
2. To connect the high pressure hose to the pressure
washer unit 7 , screw the hose collar
pressure water outlet
nOTE: Uncoil the high pressure hose before installation
to prevent kinks.
nOTE: Avoid cross threading when installing the hose.
Cross threading will cause leaks.
Attaching Garden Hose (Fig. K)
1. To connect a garden hose to the pressure washer unit
place the end of a garden hose
intake 10 . Tighten the garden hose by hand.
2. Always disconnect the garden hose after usage.
nOTE: Before connecting the garden hose to the
pressure washer unit, run water through the garden
hose for thirty seconds to clear any debris from the
mouth of the garden pressure hose.
Fig. I
Fig. J
43
6
1 to the spray
41 onto the inlet
41 onto the high
43 .
44 inside the water
3
Fig. K
Attaching Nozzles (Fig. L)
7 ,

DANGER: Risk of fluid injection. Do not direct
discharge stream toward persons, unprotected skin,
eyes or any pets or animals. Serious injury will occur.

WARNING: Flying objects could cause risk of serious
injury. DO NOT attempt to change nozzles while
pressure washer is running. Turn pressure washer unit
OFF before changing nozzles.
1. To connect a nozzle to the spray wand
42
connect collar
appropriate nozzle.
2. Release the quick connect collar to lock the nozzle
in place.
3. To ensure nozzle is locked into place, give the nozzle
a firm tug after the quick connect collar has locked
41
into place.
Spray Tip
15° Orange Nozzle
1
25° Green Nozzle
40° White Nozzle
Soap Nozzle
Black Turbo Nozzle For abrasive cleaning.
Fig. L
7
2
45 toward the spray wand and insert the
Application
For brick or masonry.
For vinyl siding.
For automotive washing.
For gentle wide area cleaning.
2
44
10
, pull the quick
45