Pearl H-1030 Instruction Manual

Hi-hat stand

H-1030 /H-1030S

To get optimum performance from your H-1030 / H-1030S Hi-Hat Stand,

Pull Rod

Upper Tube

Wing Nut

Base

Radius Rod

PEARL HI-HAT STAND

Instruction Manual

Congratulations on your purchase!

please read this Instruction Manual before playing.

Hi-Hat Clutch

Hi-Hat Cup

StopLock

Die-Cast Joint

Wing Bolt

Spring Tension

•Adjustment Dial

H-1030

Rubber Tip

Footboard

H-1030S

Table of Contents

Need help?

Do you have a question about the H-1030 and is the answer not in the manual?

Page 1 PEARL HI-HAT STAND H-1030 /H-1030S Instruction Manual Congratulations on your purchase! To get optimum performance from your H-1030 / H-1030S Hi-Hat Stand, please read this Instruction Manual before playing. Hi-Hat Clutch Pull Rod Hi-Hat Cup Upper Tube StopLock Die-Cast Joint...
Page 2 Footboard Attachment / Base Assembly Upper Section Assembly Remove the Pull Rod from the Upper Tube. Loosen the Lay the Base Assembly horizontally on the floor. Squeeze Wing Bolt on the Hi-Hat Clutch and remove it from the Pull the Radius Rods together and insert the ends into the Rod.
Page 3 Attaching the Hi-Hat Cymbals CAUTION Please have your Hi-Hat Cymbals ready. First, place the The Base Tube is secured to the Support Casing with an Allen Screw. Periodically check it for tightness and if it's loose, Bottom Cymbal on the Hi-Hat Cup as shown (Fig.5). tighten it with the provided Allen wrench to restore stability Remove the Bottom Lock Nut and one of the Felt Washers (Fig.8).

H-1030s