Pearl H-1000K Instruction Manual

Hi-hat stand

Table of Contents

Download this manual

PEARL HI-HAT STAND

To get optimum performance of your H-1000K Hi-Hat Stand,

please read this Instruction Manual before playing.

Pull Rod

Upper Tube

Base

Support Casting

Footboard Angle

Adjustment System

Reversible

Rubber/Spiked Tipped Feet

H-1000K

Instruction Manual

Congratulations on your purchase!

Hi-Hat Clutch

Rubber Cymbal Seat

Hi-Hat Cup

Stop Lock

Die-Cast Joint

Wing Bolt

Pulley-Drive

Toe Stop

TractionPlate w/ Traction Grips

Radius Rod

Table of Contents

Do you have a question about the H-1000K and is the answer not in the manual?

Page 1 PEARL HI-HAT STAND H-1000K Instruction Manual Congratulations on your purchase! To get optimum performance of your H-1000K Hi-Hat Stand, please read this Instruction Manual before playing. Hi-Hat Clutch Pull Rod Rubber Cymbal Seat Hi-Hat Cup Upper Tube Stop Lock Die-Cast Joint...
Page 2 Footboard Attachment Upper Section Assembly Squeeze the Radius Rods together and insert the ends into Thread the Upper Pull Rod into the Connector as shown in (Fig. the holes in the Support Casting as shown (Fig. 1). Stand 4-A) until the Lock Nut presses securely against the Connector. the hi-hat base vertically by adjusting the width of the legs.
Page 3 Fig. 9 To protect the chain from damage when transporting your H-1000K it is advisable to remove the chain from the footboard. To remove the chain, remove the Key Bolt as shown in (Fig.10.) After removing the chain, thread the Key Bolt finger tight back into the footboard for safe keeping until the chain is reattached.
Page 4 CAUTION Periodically check all Allen Screws for tightness and tighten them with the provided Allen Wrenches as needed. Periodically lightly lube external moving parts such as the Chain, Wing Nuts, Wing Bolts, Key Bolts, and Footboard Hinge to achieve optimum performance from your hi-hat. To maximize traction of the rubber mat beneath the heel plate, keep it clean and dust free using a damp cotton towel.