G. Paniz FCR 04 Instruction Manual page 7

ROTATING COMPACT OVEN
1.1 FC 04 oven is made both internally and externally in 430 stainless steel, with rock wool
insulation and tempered-glass door with viewing wide area .
1.2 Trays in aluminium, rotating system made by carbon steel whith chromiun bath.
1.3 Heating performed through shielded resistance, temperature control with a thermostat
that ranges between 50º and 250º, timer controls up to 120 cooking minutes.
1.4 420 Internal lights, rotatory system and internal ventilation are activated independently .
2.1 Install equipment on a flat surface.
2.2 Before plugging the equipment to the electric power supply, make sure that voltage
recommended is the same supplied at your facilities.
2.3 Your FC 04 oven is equipped with single voltage 220V motors and resistance.
LEARN TO USE YOUR FCR 04 OVEN
3.1 Adjust the temperature for cooking by pressing
3.2 Start turbine by pressing
3.3 Adjust cooking time by pressing
3.4 Pre heat the oven at the cooking temperature, which varies according to the product that
is going to be cooked.
3.5 Place product to be cooked in the oven, and adjust time by pressing
and press the roting system boton
3.6 Turn on the lamp by pressing
4.1 Before cleaning the equipment, make sure it has been unplugged from power supply.
4.2 To clean equipment internally and externally, use only a wet cloth.
°C
8
ROTATING COMPACT OVEN
- Be sure to keep this manual for future reference.
- Installation should be done in accordance with the manufacturer's directions by qualified and
component people.
- In case of repairs, use exclusively technical assistence authorized manufacturer, requesting
original replacement parts.
- Failure to follow directives may put in risk operator's safety.
- Make contact with distributor whom you trust to obtain the authorized assistence center
nearest you.
- The manufacturer reserves the right to alter, any moment, and without prior notice the
contents of this manual.
- This manual provides technical information for a correct installation and functioning of the
equipment. The operator has the duty and responssibility to be guided by it. Contents includ a
description of the caracteristics, funtioning, installation and maintenance, as well as aspect
pertaining to operator safety.
- Before using the equipment, it is necessary to consult this manual. We recommend that it be
read carefully and that its instruction be followed rigorously. To preserve operator safety, the
equipment should be maintained in perfect condition.
- This manual is an integral part of the equipment, and should be kept in a place of easy access,
known by all of its operators, and made avaliable to all persons responsible for its functioning
and repair.
- Before using the equipment, and each time that a doubt arises about its functioning, each
operator has the responsability of reading carefully this manual.
- In the process of product installation or during maintenance, use all responsible means
necessary to prevent injury to peaple and to the machine.
- Upon finishing the removal or neutrlization of any part related to the safe use of the machine
(sensors protective parts, etc.) Replacethem in their proper place and make sure that the
security mechanisms are correctly positioned.
- The merchandise is shipped at the client's risk. Any claims that may be made concerning a
defective condiction of the machine should be presented to the shipper at the time of delivery.
!
5