Cleaning And Maintenance - Bimar VR28 Instruction Booklet

Control panel with switches for the following functions:
" "
 button: cools the air and
evaporates micro-particles of H²O it is
filled with: this function is most effective
in drier air, and is less effective as relative
humidity increases (RH).
The button starts and stops the water pump. If the water is finished, switch off
the cooling function using the button.
 Selector (12): turn the selector knob to the desired speed: (0=off; 1=min; 2=
med; 3=max).
" "
 button, see above.
USE
To start the appliance, plug it into the mains and choose the required functions.
To turn the unit off completely, after set the selector to
from the plug point.
If the appliance is not being used for long periods of time, remove the plug from
the plug point and empty the water tank.

CLEANING AND MAINTENANCE

Important: before performing routine cleaning, remove the plug from the mains.
 Regularly check that the filters are clean and that the water in the tank does
not contain deposits or substances to ensure that the functions are as effective
as possible.
 To clean the filters, remove the lids and clean the dirt with a vacuum cleaner or
a brush, making sure that the surfaces are not damaged, and rinse with
running water. Allow to drip dry completely, place filters with sides and lids
back in position.
 To clean the tank use a soft cloth to remove any deposits on the surface,
taking care not to damage the pump and other parts.
 To clean the body, use a soft cloth dampened with water and, if necessary, use
also a mild everyday detergent.
 Do not use abrasive or corrosive products.
 Do not immerse any electrical parts in water or another liquid. In the event this
occurs, dry carefully and check that the electric parts are perfectly dry and,
17/48
" "
0 , remove the plug