Table of Contents
Advertisement
2.6
Assembly - Handlebar
Before assembly, take a close look at the individual assembly steps shown and carry out the assembly
in the order given.
NOTICE
L
First loosely screw all parts together and check that they fit properly. Tighten the screws using
the tool only when you are instructed to do so.
Step 1:
Mounting the Armrest
1.
Slide the armtest (G) onto the adjsutable tube (F).
2.
Fix the armrest (G) to the adjustabel tube (F) using a total of
two cylinder head bolts (J), four washers (K) and two safety
nuts (L).
3.
Tighten the bolts and nuts.
Step 2:
Mounting on the trampoline and connecting the tubes
1.
Fix the support tube (A) to the socket on the
trampoline using the two knobs (E).
2.
Release the quick release clip (B) and slide the quick
release clip (B) onto the support tube (A) on the
plastic bushing.
3.
Slide the adjustable tube (F) into the support tube (A)
and set the desired height.
4.
To fix the height, open the spring clip (C) and insert
the pin of the spring clip (C) into the slot of the
support tube (A) and through one of the slots on the
adjustable tube (F).
5.
Lock the quick release clip (B) and the spring clip (C).
G
L
F
B
C
A
E
J
K
F
13
Advertisement
Table of Contents
