Table of Contents
Advertisement
Step 2:
Fixing the Jumping Mat
1.
Lay out the jumping mat (H4) with the loops facing down.
2.
Adjust the plastic holders on the jumping mat so that the holder
on the top rail (H2) is between two plastic holders and start on the
opposite side of the holder on the top rail, see Fig. 8.
3.
Hook one end of the first bungee cord (H5) into the right side of
the left plastic holder, see Fig. 8 and Fig. 4.
4.
Run the bungee cord (H5) upwards over the top rail and trough
the first loop on the right from below.
NOTICE
L
For securing during tightening, you can use the quick clips (H9),
see Fig. 5.
5.
Proceed the same way for the other loops until you reach the next
plastic holder, see Fig. 6.
6.
Run the bungee cord (H5) at the last loop from below over the top
rail to the plastic holder and hook the bungee cord (H5) into the
left side of the plastic holder, see Fig. 7.
7.
Run the second bungee cord (H5) on the opposite side from
the plastic holder through the loops of the jumping mat (H4) as
described in the steps 3–6.
8.
Run the next bungee cords (H5) from the plastic holders through
the loops of the jumping mat (H4) as described in the steps 3–6.
࣑ ATTENTION
Make sure that the bungee cords (H5) are always installed at the
opposite positions, see Fig. 8 and Fig. 9.
Fig. 8
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 9
11
Advertisement
Table of Contents
