Advertisement
Sapper™ Horsepower Mount for 30lb. Monitor
STEPS
CONNECT THE MAST TO THE
HORSEPOWER ASSEMBLY:
1.
Insert four M6 spring nuts (I) into the
bottom beam of the pre-assembled
Horsepower assembly with the spring tabs
facing upward (two nuts per channel.)
2.
Align the spring nuts (I) with the holes in the
base mounting bracket (H) and attach the
base mounting bracket (H) using (4) M6-1
x 14mm flat head machine screws (G).
3. Install top mounting bracket bushing
(J) by aligning snap tabs and mating
slots. Press and snap into place.
4. Insert two M6 spring nuts (I) into the top
beam of the Horsepower assembly with
the spring tabs facing downward.
5. Align the spring nuts (I) with the holes in the
top mounting bracket (K) and attach the top
mounting bracket (K) to the spring nuts (I) with
(4) M6-1 x 25mm flat head machine screws (L).
Be sure the brackets are vertically
aligned before tightening the screws.
6. Insert the mast (A) through the hole in the top
mounting bracket (K) and press firmly onto the
curved ribs of the base mounting bracket (H).
Horsepower™ Installation Guide
July 2016
7.
Attach the mast (A) to the base
mounting bracket with a ½-13 x 1.5"
Flat Head Socket Screw (F).
8. Repeat steps 1-6 for the second mast,
positioning the second top mounting
bracket directly adjacent to the first.
CONNECT THE MONITOR MOUNT TO THE MAST:
9. Remove monitor base and hardware,
from the monitor. Retain all hardware.
10. Remove the mast caps (B) and the stop
screws (E) from the top of the masts (A).
11. Rotate the height adjustment knobs (C) to
the desired height. (Note: The Knoll logo on
the adjustment knobs should be face up.)
12. Slide the sleeve mount (M) onto and down
the masts (A) until they rest securely on
the height adjustment knobs (C).
13. Reinstall the mast caps (B)
and the stop screw (E).
Horsepower
14. Attach the VESA plate to the VESA bracket
5
using (4) 20 x
/
" machine screws. Place the
8
VESA plate assembly (O, P, or Q) against
back of monitor or television and attach using
appropriate customer supplied hardware. VESA
plates can accommodate 100mm, 200mm, or
400mm hole patterns.
: VESA plates can hold up to 30lbs.
: Check VESA compliancy and hole
pattern on monitor or television as Knoll
monitor solutions are designed to work
with VESA compliant monitors only. Knoll
VESA plates do not ship with screws and
are designed to accept an M4 or M5 screw;
length is dependent on the specific monitor or
television and screw should be tested prior to
installation to ensure correct length; Knoll is
not responsible for use of incorrect screws.
15. Attach VESA plate (O, P, Q) to sleeve arms
(M) by inserting fast release pins (N).
16.
To activate the anti-theft
feature, back the set screw at the
bottom of the fast release pin partially
out with a
1
/
" Allen wrench.
16
™
15
Advertisement
