Connector Pin Depth Information - HP 85091A Reference Manual

Specifications and Characteristics

Connector Pin Depth Information

Connector Pin Depth Information
Table 2-3 3.5 mm Connector Pin Depth Limits
Device Typical Pin Depth in
micrometers (10
3.5 mm ECal Module –25.4 to –50.8 (–10.0 to –20.0)
3.5 mm Adapter –2.5 to –13.0 (–1.0 to –5.0)
1. Approximately +2 sigma to –2 sigma of gauge uncertainty based on studies performed at the factory using analog gauges
according to recommended procedures.
Table 2-4 7 mm Connector Pin Depth Limits
Device Typical Pin Depth in
micrometers (10
7 mm ECal Module –25.4 to –50.8 (–10.0 to –20.0)
1. Approximately +2 sigma to –2 sigma of gauge uncertainty based on studies performed at the factory using analog gauges
according to recommended procedures.
Table 2-5 Type-N 50
Device
Typical Pin Depth
micrometers (10
Type-N 50 Ω ECal Module –25.4 to –50.8 (–10.0 to –20.0) +3.8 to –3.8 (+1.5 to –1.5)
Type-N 50 Ω Adapter
0 to –12.7 (0 to –5.0)
1. Measured from a 5.258 mm (0.207 inches) nominal offset.
2. Approximately +2 sigma to –2 sigma of gauge uncertainty based on studies performed at the factory using analog gauges
according to recommended procedures.
1. Hewlett-Packard does not supply pin depth gauges for type-F or 7-16 connectors. The type-F mod-
ule adapter pin depth is set at –25.4 to –50.8 micrometers. The 7-16 module adapter pin depth is
set at 0 to –38.1 micrometers recessed from the nominal 1.77 mm offset between inner conductor
and outer conductor mating planes.
2-8
Measurement Uncertainty
–4
inches)
in micrometers (10
+1.3 to –1.3 (+0.5 to –0.5)
+1.3 to –1.3 (+0.5 to –0.5)
Measurement Uncertainty
–4
inches)
in micrometers (10
+1.3 to –1.3 (+0.5 to –0.5)
Ω
Connector Pin Depth Limits
1
in Measurement Uncertainty
–4
inches) in micrometers (10
+3.8 to –3.8 (+1.5 to –1.5)
1
1 Observed Pin Depth Limits
–4 in micrometers (10
inches)
–24.1 to –52.1 (–9.5 to –20.5)
–1.2 to –14.3 (–0.5 to –5.5)
1 Observed Pin Depth Limits
–4 in micrometers (10
inches)
–24.1 to –52.1 (–9.5 to –20.5)
2 Observed Pin Depth Limits
–4 in micrometers (10
inches)
–21.6 to –54.6 (–8.5 to –21.5)
+3.8 to –16.5 (+1.5 to –6.5)
–4
inches)
–4
inches)
–4
inches)
Chapter 2