Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for MAHLE CAD-FL
Summary of Contents for MAHLE CAD-FL
- Page 1 MAHLE CAD-FL & CAD-FL3 Operation Manual CML Forklift adapter...
- Page 2 EVERY PERSON WHO OPERATES THIS EQUIPMENT NEEDS TO KNOW AND UNDERSTAND ALL OF THE INFORMATION IN THIS MANUAL – FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH. READ THIS MANUAL CAREFULLY AND RETAIN FOR YOUR RECORDS...
-
Page 3: Table Of Contents
Contents CAD-FL & CAD-FL3 | 3 | en Contents 1. Safety Regulations ..........4 Safety Instructions ........4 2. Foreword..............5 2.1 From the manufacturer ........5 3. Symbols Use ............5 3.1 Signal words ............5 4. Responsibilities ............6 4.1 Receiving inspection.........6 4.2 Owner and/or operator responsibilities .....6 5. -
Page 4: Safety Regulations
| 4 | CAD-FL & CAD-FL3 1. Safety Regulations NEVER place hand or any other body part between lift platform and vehicle, personal injury can occur. 1.1 Safety Instructions NEVER lift a forklift by the counterweight. To avoid serious injury or death, read this manual carefully before installing and using the forklift adapter system. -
Page 5: Foreword
CAD-FL & CAD-FL3 | 5 | en 2. Foreword 3. Symbols Use 2.1 From the manufacturer 3.1 Signal words Thank you for your purchase. To complement the offering Signal words call attention to a safety message or of A/C, fluid and nitrogen service equipment, MAHLE... -
Page 6: Responsibilities
| 6 | CAD-FL & CAD-FL3 4. Responsibilities 5. Specifications Model CAD-FL & FL3 US units Metric units 4.1 Receiving inspection Before attempting to operate this equipment, thoroughly System Capacity 15,000 lbs. 6803.9 kg read and understand this manual. Completely remove all... -
Page 7: Component Identification
CAD-FL & CAD-FL3 | 7 | en 6. Component Identification... -
Page 8: Operation
| 8 | CAD-FL & CAD-FL3 WARNING! Only use Forklift Adapter Mode with a 7. Operation manufacturer supplied forklift adapter. 6. The display will now appear as shown below with 7.1 Installation Instructions a picture of a vehicle asking for the current lift The adapter components are heavy and will require two unit’s position relative to the vehicle. - Page 9 CAD-FL & CAD-FL3 | 9 | en 13. With the Lift Carriages raised, install the four Tire Supports as shown in the figure below. The Tire Support Platform must set on the lift unit’s base leg and the front wheel must protrude from the Tire Support Platform such that the platform is retained on the base of the lift unit.
-
Page 10: Structural Inspection
| 10 | CAD-FL & CAD-FL3 15. If the 3 wheel adapter is to be used, align the tabs serviced or if you have any questions about how to on the Lateral Support Bar with the ramps and address any wear or damage observed on the equipment. -
Page 11: Notes
CAD-FL & CAD-FL3 | 11 | en 9. Notes... - Page 12 MAHLE Aftermarket Inc. 916A West State Street St. Johns, Michigan 48879-1401 U.S.A. Phone: (800) 468-2321 E-mail: tech.mss@us.mahle.com www.servicesolutions.mahle.com...