Leveling; Installing The Backguard - GE JEG3002BBE Manual

2.2 Leveling

We recommend to level the range before performing gas and electric
connections in order to achieve even baking results.
Your range has two leveling bolts located at the rear of the range's floor. Place the range
on its installation spot.
Place a level over oven's shelves.
If range is not level, tilt the range on its side -with the help of a second person- and turn
the bolt. Repeat the operation on the other side until achieving the desired height.

2.3 Installing the backguard

Step 1
Unpack backguard located on the back of the range.
Step 2
Place backguard over cooktop and make sure that the holes on both parts match so the back-
guard is correctly seated (see photograph).
Step 3
Place all 4 Phillips bolts on the top face of the backguard and the bottom face of the cook-
top, firmly tighten with the nuts. Use pliers or a 9,5 mm (3/8") open-end wrench.
photograph 1 photograph 2
Step 4
Place the metallic supports in diagonal position (see photograph 2).
26