Honda CB250 TWISTER Owner's Manual page 127

CB250 TWISTER
Changing Engine Oil & Filter
Changing the oil and filter requires special tools. We
recommend that you have your motorcycle serviced
by your dealer.
Use a new Honda Genuine oil filter or equivalent
specified for your model.
N
OTICE
Using the wrong oil filter can result in serious
damage to the engine.
1. If the engine is cold, idle the engine for 3 to
5 minutes.
2. Turn the ignition switch off, stop the engine and
wait for 2 to 3 minutes.
3. Place your motorcycle on a firm, level surface.
4. Place a drain pan under the drain bolt.
5. Remove the oil fill cap/dipstick, drain bolt, and
sealing washer to drain the oil.
1
2
1. Sealing washer
2. Drain bolt
6. Remove the oil filter cover, oil filter and spring by
removing the oil filter cover bolts.
Discard the oil and oil filter at an approved
recycling centre.
7. Install the spring and new oil filter with the
"OUT-SIDE" mark facing out.
8. Replace the O-ring and apply a thin coat of engine
oil to the new O-ring before installing it.
9. Install the oil filter cover by tightening the oil filter
cover bolts.
41