AEG MC 4428 CD Instruction Manual page 43

• Replace the cell by a battery of the same type
(CR 2025). Ensure correct polarity.
• Then close the battery lid.
If the remote control is not used for a prolonged period,
remove the batteries in order to prevent battery acid
leaking.
CAUTION:
Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer's.
WARNING:
• Do not expose the batteries to high temperatures
or direct sunlight. Never throw batteries into the
fi re. There is a danger of explosion!
• Keep batteries away from children. They are not a
toy!
• Do not open the batteries by force.
• Avoid contact with metallic objects. (Rings, nails,
screws et cetera.) There is a danger of short-circui-
ting!
• As a result of a short-circuit batteries may heat up
considerably or even catch fi re. This may result in
burns.
• For your own safety the battery poles should be
covered with adhesive strips during transport.
• If a battery leaks do not rub the liquid into your
eyes or mucous membranes. If hands come into
contact with the liquid they should be washed
thoroughly and eyes rinsed out with clear water;
if symptoms persist please consult a doctor.
CD deck transport protection
• Please open the CD compartment (1) by pressing the
OPEN (open) button (3).
• Remove the transport protection from the CD player
if present before use.
General Operation
NOTE:
Some keys are to be found both on the device itself
and on the remote control. Keys with the same desi-
gnation have the same function.
Volume
The desired volume can be sent using the VOLUME /
regulator (7).
Switch-off
The machine is switched off when the function selector
switch (9) is turned to the OFF position. Unplug the
device.
05-MC 4428 CD AEG.indd 43 05-MC 4428 CD AEG.indd 43
AUX IN socket
To connect analogue replay devices. Via this socket you
can also hear the sound of other playback devices such
as MP3 players, CD players etc. through the loudspeakers.
1. Please connect the external device with a 3.5 mm
stereo jack plug to the AUX IN socket (17).
2. Turn the function selector switch (9) to CD/MP3 or
RADIO. The device switches automatically to AUX IN
operation. The radio or CD sound is switched off .
3. Through the loudspeakers you can hear the playback
of the sound from the external device; with the
VOLUME control (7) you can change the volume. The
CD buttons do not have any function.
4. For the remaining procedure please see the operating
instructions of the external sound source.
NOTE:
Adjust the volume of the external device to a comfor-
table level.
Listening to the Radio
1. Turn the function selector switch (9) to the RADIO
position.
2. Use the band selector switch (10) to select the desired
frequency band.
VHF (Stereo) = FM ST., VHF = FM,
Medium wave = AM (Mono)
3. Tune in the desired station with the station adjust-
ment knob TUNING (6).
4. The FM.ST control lamp (16) only lights up when
you have selected FM stereo and the station is being
received in stereo quality. If reception is too weak
and there is noise on the station being received, this
lamp will fl icker.
5. Try to improve reception by turning and bending or
twisting and altering the length of the antenna (18).
Where reception is bad we recommend switching
to FM.
6. An aerial is integrated into the device for the recep-
tion of AM stations. The machine can be aligned
to the station by turning it. In this frequency band
programs are transmitted in „mono" only.
Playing CDs/MP3
This is how you play a CD
1. Turn the function selector switch (9) to the „CD/MP3"
position.
2. In order to open the CD compartment (1), press the
OPEN button (3).
3. Insert an audio CD with the printed side facing up-
wards on to the central cone so that the CD clicks into
place and then close the lid of the CD compartment.
4. After a few seconds the total number of songs/tracks
is shown in the display.
English
43
29.12.2009 15:44:00 Uhr 29.12.2009 15:44:00 Uhr