Rapid Group WX 90 Operating Instructions Manual page 2

+49 (6155) 84 20-0
1. SAFETY
All safety instructions must be observed and followed.
2. Before Using
2.1. There is high speed rotating components. Failure to follow the
safety instructions may lead to serious injury. All safety instructions
must be observed and followed strictly.
2.2. Before installing and starting the barrel pump, the related
engineer must have the considerable qualification and is familiar
with this manuals.
2.3. The installation and maintenance must according to the current
machinery and electrical standard strictly.
2.4. The spare parts life time will be limited by wear and corrosion.
The failure is affected by operating environment. The user has the
responsibility to operate in accordance with the regulations. The
regular maintenance and spare parts change should be performed
regularly. Stop the pump when the pump under irregularity and
obviously dangerous status.
2.5. The pump should install the detection alarm system when it
was installed at the location where may cause the failure or
personal injury.
3. Using
3.1. Wear protective clothing, goggles and in accordance with the
safe production routine when operate the corrosive and hazardous
substance.
3.2. It is prohibited to use plastic or aluminum alloy pump pipe and
the non-explosion proof motor when transferring the flammable
liquids.
3.3. Carry flammable liquids, the earth wire must be installed,
electrostatic protection device and conductive hose must be used
when transferring the flammable liquids.
3.4. Make sure the pump head insert to the liquids completely
before using. Also all the connectors connect tightly. Without
leakage and fall out dangerous situation.
3.5. The suitable flexible pipe must be used during transferring high
temperature liquids.
3.6. Attention to the pumped liquids temperature, viscosity and
density do not exceed the stated upper limit.
2