Table of Contents
Advertisement
Quick Links
V10MR User Programming Guide
Your new V10MR, in its default state, works correctly with other new (no programming changes) V10MR
radios. Please refer to your instruction manual for basic steps to operate the radio with no
programming changes.
Should you want to change channel assignments, tones, or special features, your V10MR radio has a
number of advanced radio features that can be enabled through its software (CS-V10MR).
To program the radios, you will need the following:
•
CS-V10MR Cloning Software. Available for free download on the Icom America website
(Products >Landmobile >V10MR).
•
OPC 478UC Cloning Cable ("B" version only). Available from an Icom America Landmobile Dealer
in your area.
•
PC running Windows 10 operating system. Note: Apple and Android software is not available.
Default Channels/Frequencies and Tone
Channel
Frequency
1
151.820MHz
2
151.880MHz
3
151.940MHz
4
154.570MHz
5
154.600MHz
CS-V10MR Software Modes
The CS-V10MR software has two modes, Simple and Full.
Simple Programming Mode: Allows adding duplicates of the 5 MURS frequencies for the purpose of
using different CTCSS or DTCS tones.
Full Programming Mode: Allows adding duplicates of the 5 MURS frequencies and the addition of a
larger suite of features.
Note: Incorrect Settings in the Full Programming Mode can cause incorrect operation of the radio. Icom
suggests these features be programmed by an Icom dealer only.
Bandwidth
CTCSS tone
Narrow
67Hz
Narrow
67Hz
Narrow
67Hz
Wide
67Hz
Wide
67Hz
1
Knowledge Base |
©2021 Icom America Inc. The Icom logo is a registered trademark of Icom Inc.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Icom V10MR
Summary of Contents for Icom V10MR
- Page 1 Knowledge Base | V10MR User Programming Guide Your new V10MR, in its default state, works correctly with other new (no programming changes) V10MR radios. Please refer to your instruction manual for basic steps to operate the radio with no programming changes.
- Page 2 6 PWR Save This feature saves power by allowing the radio to go into a partial sleep mode during times when there is no RX or TX traffic. ©2021 Icom America Inc. The Icom logo is a registered trademark of Icom Inc.
- Page 3 1. Scan Settings screen- Set Power-On Scan to one of the following choices: Off- User will have to press the Scan Start/Stop button to start a scan after power up. • ©2021 Icom America Inc. The Icom logo is a registered trademark of Icom Inc.
- Page 4 4. In Cancel Channel, set the channel that you will return to when scan is cancelled using the Scan Start/Stop button, assigned in the Key and Display screen as described below. ©2021 Icom America Inc. The Icom logo is a registered trademark of Icom Inc.
- Page 5 All participating radios are also programmed for MDC emergency functions. PTT ID PTT ID allows your V10MR radio to send its own ID to another radio that has a display. Note: Icom does not make MURS radios with displays. 1. Go to Memory Ch.
- Page 6 2-Tone Signaling and Muting is used only in specialized systems such as those in Fire Departments. If this radio is approved to operate on such a system, please contact the administrator for the programming parameters for that system. ©2021 Icom America Inc. The Icom logo is a registered trademark of Icom Inc.
Need help?
Do you have a question about the V10MR and is the answer not in the manual?
Questions and answers