Safety Information - Earthsafe M500 Installation, Operation And Maintenance Manual

INSTALLATION, OPERATION, AND MAINTENANCE
Safety notices – General Safety Rules – Symbols
SAFETY INFORMATION AND INSTRUCTIONS
Danger — Failure to follow the indicated instruction may result in serious injury or death.
Warning — In addition to possible serious injury or death, failure to follow the indicated
instruction may cause damage to pump and/or other equipment.
IMPROPER INSTALLATION, OPERATION OR MAINTENANCE MAY CAUSE SERIOUS INJURY
OR DEATH AND/OR RESULT IN DAMAGE TO UNIT AND/OR OTHER EQUIPMENT.
EARTHSAFE'S WARRANTY DOES NOT COVER FAILURE DUE TO IMPROPER INSTALLATION,
OPERATION OR MAINTENANCE.
THIS INFORMATION MUST BE FULLY READ BEFORE BEGINNING INSTALLATION,
OPERATION OR MAINTENANCE OF EQUIPMENT AND MUST BE KEPT WITH EQUIPMENT.
EQUIPMENT MUST BE INSTALLED, OPERATED AND MAINTAINED ONLY BY SUITABLY
TRAINED AND QUALIFIED PERSONS.
THE FOLLOWING SAFETY INSTRUCTIONS MUST BE FOLLOWED AND ADHERED TO
AT ALL TIMES.
Symbol Legend:
Danger — Failure to follow the indicated instruction may result in serious injury or death
Warning — In addition to possible serious injury or death, failure to follow the indicated
instruction may cause damage to pump and/or other equipment.
BEFORE opening any pipe system, pump, or valve be sure that:
• Any pressure in the chamber has been completely vented through the suction or
discharge lines or other appropriate openings or connections.
• The electrical system system means has been "locked out" or otherwise been made
non-operational so that it cannot be started while work is being done on the equipment.
• You have obtained appropriate material safety data sheet (MSDS) and understand and
follow all precautions appropriate for the safe handling of the material.
INSTALL pressure gauges/sensors at piping and pump connections to the equipment to
monitor pressures.
USE extreme caution when lifting the pump. Suitable lifting devices should be used when
appropriate.
DO NOT attempt to dismantle a pressure relief valve that has not had the spring pressure
relieved or is mounted on a pump that is operating.
AVOID contact with hot areas of the pump or equipment. Certain operating conditions,
temperature control devices, improper installation, improper operation, and improper
maintenance can all cause high temperatures on the pump or equipment.
Pumps and piping systems must be provided with pressure protection.
THE equipment must be installed in a matter that allows safe access for routine maintenance
and for inspection during operation to check for leakage and monitor operation.
Generator Day Tank
EMERGENCY POWER FUEL SYSTEMS
(danger-warning-caution)
Earthsafe M500
4 of 15
earth safe
Fuel Systems for Critical Power