IBM BladeCenter LS42 Installation Manual page 22

10. If your BladeCenter unit has a bezel assembly, install it now. For detailed
If this is the initial installation for the blade server in the BladeCenter unit, you
must configure the blade server through the Configuration/Setup Utility program
and install the blade server operating system (see the Installation and User's Guide
for your blade server for instructions).
12
IBM BladeCenter: LS42 Multiprocessor Expansion Unit
configuration information and update options are established according to
bay number. Reinstalling a blade server into a different blade bay from the
one from which it was removed could have unintended consequences, and
you might have to reconfigure the blade server.
5. Make sure that the release levers on the blade server are in the open position
(perpendicular to the blade server).
6. Slide the blade server into the blade bay until it stops.
7. Push the release levers on the front of the blade server to the closed position.
8. Turn on the blade server (see the Installation and User's Guide for your blade
server for instructions).
9. Make sure that the power-on LED on the blade server control panel is lit
continuously, indicating that the blade server is receiving power and is turned
on (see the Installation and User's Guide for your blade server for instructions).
instructions for reinstalling the bezel assembly, see the Installation and User's
Guide that comes with your BladeCenter unit.