Advertisement
Starting with the End Glazing Bar, push this bar into the wall plate so that it is pushed back as far as
possible and ensure the outside profile lines up with the edge of the wall plate. Rest the other end of
the glazing bar on the radius inner section of the gutter section.
Using a 6.5mm drill bit, drill 1 No. hole through the bottom radius profile of the wall plate ensuring
this also goes through the flat section of the glazing bar. Locate a 6mm x 16mm pan pozi screw bolt
through the hole and apply m6 nyloc nut. Using an 8mm ratchet and screw driver tighten up.
Repeat this process on the other side of the glazing bar. Please see the image below:
Make sure the glazing bar is in line with the gutter beam, then using the same fixing method as the
wall plate secure the glazing bar to the gutter section. Your pre-drilled holes will determine where
you drill through on the radius of the gutter section. Please see diagram below:
Repeat the above with the last glazing bar at the other end of the wall plate and gutter beam to
stabilise the wall plate and gutter beam while you seal the wall plate in the following section.
DO NOT FIT ANY MORE GLAZING BARS AT THIS STAGE
STEP 10
Sealing Wall Plate Against the Wall
If flashing or silicone is required to seal the wall plate against the wall, it needs to be done prior to
the glass sheets being fitted.
STEP 11
Glass Sheets
The glass sheet comes with a protective film fitted on the coated face. This needs to be removed
prior to fitting. The side with the film needs to be fitted facing the sunlight.
PLEASE NOTE IF USING SELF CLEANING GLASS A MINIMUM PITCH OF 10° IS REQUIRED.
9
Advertisement
