Table of Contents
Advertisement
Quick Links
SNOW CAB #1694921
FOR
Regent, LT 200 Series,
500 Series Lawn Tractors,
2500 Series Lawn Tractors
PARTS LIST – ASSEMBLY INSTRUCTIONS
IMPORTANT !
READ THIS MANUAL CAREFULLY AND KEEP FOR FUTURE REFERENCE
CAUTION !
REMOVE THE VINYL PANELS FOR TRANSPORT IN AN OPEN TRUCK OR TRAILER
WARNING !
THIS CAB WILL NOT PROTECT OPERATOR FROM INJURIES CAUSED BY ROLLOVER,
COLLISION, OR OTHER ACCIDENTS
1
11574506
Advertisement
Table of Contents
Related Manuals for Simplicity Snow Cab 1694921
Summary of Contents for Simplicity Snow Cab 1694921
- Page 1 SNOW CAB #1694921 Regent, LT 200 Series, 500 Series Lawn Tractors, 2500 Series Lawn Tractors PARTS LIST – ASSEMBLY INSTRUCTIONS IMPORTANT ! READ THIS MANUAL CAREFULLY AND KEEP FOR FUTURE REFERENCE CAUTION ! REMOVE THE VINYL PANELS FOR TRANSPORT IN AN OPEN TRUCK OR TRAILER WARNING ! THIS CAB WILL NOT PROTECT OPERATOR FROM INJURIES CAUSED BY ROLLOVER, COLLISION, OR OTHER ACCIDENTS...
-
Page 2: Maintenance Instructions
This cab is designed to provide foul weather protection only. It does not provide protection from noise, exhaust fumes, chemicals or injury from collision, roll-over or other accidents. 1. Do not operate machine in confined areas without proper ventilation 2. Thoroughly check area of operation before using machine 3. - Page 3 For Replacement Parts and Accessories Contact: Visit us on the web to see our other products. Cabs for Lawn Tractors, Garden Tractors, Compact Tractors, Snow Blowers, Utility Vehicles Sunshades for Tractors, Mowers, & Utility Vehicles Storage Covers for Lawn and Garden equipment. . COVERED BY WARRANTY ORIGINAL TRACTOR CAB CO., INC., (the "Company") warrants to the owner that each new product listed below is merchantable and free of defects in workmanship and material.
- Page 4 Carton Contents: Snow Cab #1694921 Key # Part # Qty. Description 11594 Front Panel Frame 11593 Foot 11595 Foot Pocket Guard, RH 11596 Foot Pocket Guard, LH 10004 Front Post 10002 Top Frame Brace, RH 10003 Top Frame Brace, LH 11597 Rear Cross Bar Bracket 11598...
- Page 5 Step 1; See Figure 1: Identify the steel parts by using Figure 1. Figure 1...
- Page 6 Step 2; See Figure 2 & 2A: Install Front Panel Frame (1) A. Remove the bolt at reference A on both sides of the tractor. Place the Front Panel Frame over the dash from behind. Insert two 5/16” x 1 1/4” bolt inwards through the holes in the Front Panel Frame Legs.
- Page 7 Step 4; See Figure 4: Install right & left Front Posts (5) and right & left Top Frame Braces (6 & 7). Note: Bent ends of Top Frame Braces will point rearwards and lay flat when properly installed. A. Insert a 1/4” x 3/4” bolt forward through the tab on the post, the end of the Front Panel Frame and then the lower end of the Top Frame Brace.
- Page 8 Step 6; See Figure 6: Install right and left Rear Posts (10 & 11) and right and left Rear Boxing Posts (12 & 13). NOTE: When properly installed Rear Post latch plates will face forward with the notch to the outside A.
- Page 9 Step 8: See Figure 8: Install the Doors for frame / door alignment. A. Follow the instructions in the Door Hardware Package to install the Door Bottoms and the Door Latches. B. Install, close and latch both Doors. C. Tighten all bolts from previous steps at this time.
- Page 10 Step 10: See Figure 10: Install Rear Curtain (15). A. Lay the rod sewn into the vinyl over the rear of the Top Frame. Close the snap flaps at the corners. B. Close the snap flaps over the Rear Posts and Rear Cross Bar.