Advertisement
Model RA-2000 Installation Instructions
for backbox knockout locations
Wire Knockouts
Wire Knockouts
Figure 4: Back Box Knockout Locations
3.
Wire the Annunciator board to the main control panel. See
Figure 2.
4.
Attach the annunciator and door assembly to back box as
shown in Figure 5 using the supplied screws.
Figure 5: Attaching Annunciator/Door Assembly to
Backbox
Surface Mounting
The Model RA-2000TR red trim ring and RA-2000GRAYTR
gray trim ring kits are available for use when surface mounting.
1.
Remove the desired knock out. See Figure 4.
2.
To properly mount the back box, insert a single screw into
the key shaped mounting hole. Do not tighten all the way.
See Figure 6.
Place a level on top of the back box, with the back
2
Wire Knockouts
3.
4.
5.
6.
box level insert the rest of the mounting screws.
Key Shaped
Mounting Hole
Back Box
Mounting Holes
Figure 6: Back Box Surface Mount Holes
Run wires to the control panel.
Place the trim ring over the back box as shown in Figure 7.
Figure 7: Installing Trim Ring
Attach the Door assembly to the back box using screws
provided.
After the annunciator wiring to the panel has been
completed, replace the electronic assembly in the back box.
Place the bezel over the back box and tighten the set screws
on the bezel.
P/N 151443 Rev B
Advertisement
