Kampa Roast Master Operating Manual page 8

➤Always use gas accessories complying with the
national regulations in your country (e.g.
EN 417, EN 484 and EN 498):
– butane or propane gas container (not sup-
plied)
– gas regulator (28 – 30 mbar for butane,
37 mbar for propane) (not supplied)
– gas hose (maximum length 1.5 m) (not sup-
plied)
➤Open the lid and attach the windscreens to the
side of the oven as shown (fig. 1, page 3
➤Make sure the trivet/wire pan stand is installed
properly with the wire ends fitting into the holes
on the top of the oven.
Finding a suitable location
!
WARNING! Fire hazard
The location for setting up the hob and
oven has to meet the following require-
ments:
• outdoors only
• open, well-ventilated area which is
protected from direct winds
• placing surface for the hob and oven
– out of heat-proof, non-combustible
or non-flammable materials
– standing level on or above the
ground
• solid, stable and flat level
➤Place the device on a surface that meets the
above requirements.
➤Straighten out all hoses to make sure no kinks or
twists remain.
Connecting to a gas container
!
WARNING! Explosion hazard
• Only change gas containers outdoors
in a well-ventilated area, away from
naked flames, any other source of igni-
tion, and other people.
• Do not use the device if the sealing
washer is damaged or worn.
• Do not try to detect gas leaks using a
flame or a pilot light.
• Only connect the hob and oven to an
allowed gas container type.
8
A
NOTICE!
• Take care not to cross thread.
• Tighten the screw connection by hand
1. Attach the gas hose to the stove inlet (see
fig. 2, page 3).
2. Attach the other end to the low pressure regu-
lator (see fig. 3, page 4).
3. Be sure the regulator is correctly connected to
.
)
the gas cylinder.
4. Connect the gas regulator to the gas cylinder
following the manufacturers instruction.
5. Check that all connections are tight.
6. Turn on the gas regulator.
!
WARNING! Explosion hazard
Do not try to detect gas leaks using a
flame or a pilot light.
7. Check all connections for gas leaks:
– Coat all connections, using soapy water.
– If bubbles appear, immediately turn off the
gas regulator and re-tighten the connection
before re-testing.
– If bubbles appear again, do not continue to
use the device. Contact an authorized service
agent.
8. If no leaks are detected, turn the regulator
valve to the "OFF" position.
Using the hob and oven
!
WARNING! Fire hazard
• Make sure that all air inlets and
• The device must be operated no
4445103339
only.
exhausts are kept free from obstruction
and closure.
closer than 100 cm to the sides and
100 cm above all combustible sur-
faces, fabrics, flammable materials and
persons.