Advertisement
● Wear proper eye and ear protection. Always wear heavy-duty work gloves,
especially when changing blades or attachments.
● Check machine daily for loose bolts or nuts and torque to the correct torque
specifications. For example, the center rear wheel motor axle nut should be
torqued to at least 200 ft/lbs. Not doing this could cause the wheel and hub
to fall off and would also cause the wheel motor axle to be damaged,
resulting in high replacement costs.
● Replace worn parts when necessary.
● Do not reach into blade or control arm areas while machine is in operation.
● Be sure a qualified electrician does all electrical inspections or changes.
● Loose surface coating can cause dangerous footing. Always be alert and
careful.
● After replacing parts, make sure all tools used are removed from the
machine.
● Always lower blade to the ground when the machine is unoccupied by the
operator to prevent unintentional bodily harm with the blade.
● Never allow unauthorized personnel or the general public into the work area.
● The work area should be barricaded off to adequately keep all untrained
persons out of the work site. If an unauthorized person enters the work area,
stop the machine immediately and do not restart the machinery until they
have left the work area.
● Always allow a buffer safety zone around all surface preparation activity.
● The CYCLONE is not a toy. All operators must be over 18 years of age and
must have read and reviewed the safety and procedures manual before
operating the machinery.
● The CYCLONE is designed for surface preparation ONLY. It is not
intended for towing, pushing, or any other procedure not described in this
manual.
● No smoking or open flame is allowed while machinery is running or within
50 feet of the machine.
● Operator must be sober, not under the influence of drugs or medication, and
under full control of all bodily senses while operating this machinery.
● Always park the CYCLONE on a level surface and chock the wheels. Not
doing this could lead to the machine rolling away.
● Make sure to unplug ALL power cords before operating the CYCLONE.
6
Advertisement
