Dimplex Opti-myst Manual page 6

Dimplex Opti-myst Inset Fires
Model: Cavendish CSH20 (Brass Inset), Chesford CSD20 (Titanium Inset)
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice:
When using electrical appliances, basic
precautions should always be followed to reduce
the risk of fire, electrical shock and injury to
persons, including the following:
If the appliance is damaged, check with the
supplier before installation and operation.
Do not use outdoors.
Do not use in the immediate surroundings of a
bath, shower or swimming pool.
Do not locate the heater immediately below a fixed
socket outlet or connection box.
This appliance is not intended for use by children
or other persons without assistance or supervision
if their physical, sensory or mental capabilities
prevent them from using it safely. Children should
be supervised to ensure that they do not play with
the appliance.
Do not use this heater in series with a thermal
control, a program controller, a timer or any other
device that switches on the heat automatically,
since a fire risk exists when the heater is
accidentally covered or displaced.
Ensure that furniture, curtains or other
combustible material are positioned no closer than
1 metre from the heater.
In the event of a fault unplug the heater.
Unplug the heater when not required for long
periods.
Although this heater complies with safety
standards, we do not recommend its use on deep
pile carpets or on long hair type of rugs.
The appliance must be positioned so that the plug
is accessible.
If the supply cord is damaged it must be replaced
by the manufacturer or service agent or a similarly
qualified person in order to avoid a hazard.
Keep the supply cord away from the front of the
heater.
WARNING: In order to avoid overheating, do
not cover the heater. Do not place material
or garments on the heater, or obstruct the air
circulation around the heater.
The heater carries the Warning symbol
indicating that it must not be covered.
General.
Unpack the heater carefully and retain the packaging for
possible future use, in the event of moving or returning
the fire to your supplier. The Remote Control and batteries
are packed separately in the carton.
The fire incorporates a flame effect, which can be used
with or without heating, so that the comforting effect may
be enjoyed at any time of the year. Using the flame effect
on its own only requires little electricity.
The heater is designed for use inset into a 407mm (16") or
457mm (18") wide by 559mm (22") high fireplace opening
or freestanding - see also section 'Installation Instructions' .
Before connecting the heater check that the supply
voltage is the same as that stated on the heater.
Please note: Used in an environment where background
noise is very low, it may be possible to hear a sound which
is related to the operation of the flame effect. This is
normal and should not be a cause for concern.
Electrical connection.
WARNING – THIS APPLIANCE MUST BE EARTHED.
This heater must be used on an AC ~ supply only and the
voltage marked on the heater must correspond to the
supply voltage.
Before switching on, please read the safety warnings and
operating instructions.
PLEASE RETAIN THIS USER'S GUIDE FOR FUTURE
REFERENCE
Do not put Opti-myst plastic components into a
dishwasher.
Only slide out the drawer when the water tank needs
to be filled or a lamp needs to be changed otherwise
you will inadvertently alter the water level and the
flame effect operation.
Only use filtered tap water in this appliance.
Always ensure that the appliance is sitting on a level
floor.
If you intend not using the appliance for longer than 2
weeks, drain the water from sump and water tank and
dry the sump.
Once installed, never move this appliance or lay on its
back, without draining the water from sump and water
tank.
The water tank, sump, sump lid, tank cap and air filters
must be cleaned once every two weeks, particularly in
hard water areas.
The appliance should never be operated if the lamps
are not working.
The lamps should be regularly inspected as described
under 'Maintenance' and 'Changing lamps'.
UK