PAL SONAR RETRO Installation Manual

PAL SONAR RETRO Installation Manual

Bulb

Advertisement

Quick Links

SONAR RETRO BULB
INSTALLATION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SONAR RETRO and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for PAL SONAR RETRO

  • Page 1 SONAR RETRO BULB INSTALLATION MANUAL...
  • Page 2 CONNECTING ANY LIGHT. MISMATCHED VOLTAGE MAY RESULT IN CATASTROPHIC FAILURE OF LIGHT (VOIDING WARRANTY) AND/OR ELECTRICAL SHOCK AND SERIOUS BODILY HARM. PAL LIGHTING ACCEPTS NO RESPONSIBILTY FOR INCORRECTLY INSTALLED LIGHTS. 1) Ensure that the electrical system for your pool conforms with all the requirements of the National Electrical Code (NEC) and all relevant local codes and ordinances.
  • Page 3 BULB INSTALLATION STEP 1 Turn power off at the circuit breaker, than remove the existing light fixture from the pool light niche and place it on the pool deck. (DO NOT change light underwater) STEP 2 While the fixture is out of the pool and the lens is off, Replace the tensioning cbulb or other fasteners if stripped or damaged.
  • Page 4 STEP 3 Check the light housing for damage. Inspect the rubber seal where the power cord enters the housing for leaks or deterioration. Check the sur- face area where the lens and rubber gasket sits for imperfections. STEP 4 Make sure the inside of the light housing is completely dry.
  • Page 5 STEP 5 Install PAL Bulb STEP 6 Its highly recommended to install a new lens gasket. If not sealed cor- rectly this could result in a leak that can damage the and cause serious injury or death due to electrical shock. Install your new replacement gas- ket onto the glass lens.
  • Page 6 STEP 7 Submerge the assembled light fixture in the water and visually check that air bubbles are not escaping from the gasket area or at the power cord entrance. If bubbles appear, immediately remove the light fixture from the water and re-seat the gasket and lens. Continue the installation only if there are no air leaks.
  • Page 7 PAL Lighting. PAL Lighting shall not be liable for any loss of profits or any consequential, indirect or special loss, damage or injury of any kind whatsoever arising directly or indirectly from PAL Lighting products. This limitation does not apply to any liability under the Australian or New Zealand consumer legislation.
  • Page 8 www.pallighting.com info@pallighting.com Product info...

Table of Contents