IDENTEC SOLUTIONS IDS1000 Hardware User Manual page 5

Safety Instructions
The equipment can be installed in restricted areas.
The system described in this manual is for exclusive operation of trained employees. Only qualified personnel that
have knowledge of the potential dangers involved should perform the installation, settings, maintenance and repair
of the units used.
Operational Safety
The correct and safe use of these systems assumes that operating and service personnel follow the safety
measures described in the manual alongside the generally acceptable safety procedures.
If there is a possibility that safe operations cannot be guaranteed, the system must be switched off, secured against
accidental use and the service unit responsible immediately informed.
Safety Documents
The iQ355 P was designed, tested and supplied in perfect condition, according to document IEC/EN 60950-1
Safety Requirements.
Condensate / Change of Temperature
To avoid condensation in the system, the unit must be allowed to slowly adjust itself to warmer temperatures after
removal from cold and cool environments.
Do not open the housing
There is no need to open the housing. The unit does not have any internal setting elements or displays.
Spare Parts
We recommend that only personnel, original products, spare and replacement parts authorized by IDENTEC
SOLUTIONS be used for installation, service and repair. IDENTEC SOLUTIONS does not accept any responsibility
for materials used, work carried out or possible consequences from unauthorized third party vendors.