1. Introduction 1.1 Overview The XAiOX Prophet SiRF III GPS Receiver is a Global Position System Receiver with Bluetooth wireless technology. This BT GPS receiver allows you to receive GPS data on mobile handhelds wirelessly. By sending >GPS position data over Bluetooth, you can position the receiver for the best possible reception all without wires.
Page 6
User’s Manual XAiOX Prophet SiRF III Bluetooth GPS Receiver - 6 – Bluetooth Protocol: Bluetooth serial Communication: Distance up to 10 m GPS Protocol: NMEA-0183(V3.01) VTG, GGA, GSA,GSV,RMC Battery: Rechargeable 710mA/h Lithium-Ion Battery Charging time: approx. 3 hours Operation time: approx. 10 to 12 hours, after fully charged...
User’s Manual XAiOX Prophet SiRF III Bluetooth GPS Receiver - 7 – 3. Hardware Description LED Status Color Status LED1 GREEN OFF Unit is switched off. GREEN FLASHING Batterie is nearly empty and unit will switch off shorty. LED1 RED OFF Unit is switched off.
Page 8
User’s Manual XAiOX Prophet SiRF III Bluetooth GPS Receiver - 8 – Please press the ON/OFF button for at least 2 seconds to switch the unit ON. If the GREEN LED light is illuminated during switching ON the unit, the battery...
User’s Manual XAiOX Prophet SiRF III Bluetooth GPS Receiver - 9 – 4. Important Notes USB-Connector The USB-Connector of the GPS-Unit is only for charging purpose and not for data transfer. Car-Charger On the tip of the car charger plug there is a removable cap. Behind is a 1.5A fuse. In case of malfunction please check the fuse and maybe replace it.
User’s Manual XAiOX Prophet SiRF III Bluetooth GPS Receiver - 11 – 5. Software Installation – Pocket PC CE Example: iPAQ Bluetooth with Pocket PC Software <1> Turn Bluetooth ON <2> Click ‚Connect!’ Select ‚Bluetooth Manager’...
Page 12
User’s Manual XAiOX Prophet SiRF III Bluetooth GPS Receiver - 12 – <3> Select ‚Explore a Bluetooth device’ <4> Select <No device selected>, Then click ‘Next’. then click ‚Next’.
Page 13
User’s Manual XAiOX Prophet SiRF III Bluetooth GPS Receiver - 13 – <5> Click ‚BT-GPS’ . <6> Select ‚SPP slave’, If you are asked to enter a then click ‚Next’. password, type ‚0000’.
Page 14
User’s Manual XAiOX Prophet SiRF III Bluetooth GPS Receiver - 14 – <7> Click ‚Finish’. <8> Tap the Bluetooth icon again and BT-GPS connection is now select ‘Bluetooth setting’. established successfully.
Page 15
User’s Manual XAiOX Prophet SiRF III Bluetooth GPS Receiver - 15 – <9> Settings for TomTom Navigation Software. You can use any free Serial COM Port (outgoing)