Advertisement
Quick Links
Advertisement
Related Manuals for Innowater pH BASIC
Summary of Contents for Innowater pH BASIC
- Page 1 BASIC Operating Manual...
- Page 2 • the injection tube must be connected on one side to the peristaltic pump (right side) and on the other side to the pool return pipe via the injection valve. Innowater Tratamientos Integrales del Agua S.L. will not be held liable for the use of this device with inappropriate products.
- Page 3 DESCRIPTION The pH Basic works to correct the pH level of your pool by injecting corrective acid solution in the circuit. The device monitors the pH continuously by means of its pH sensor and sends a dosing signal to the pump which will, in turn, injects acid in the pool when needed.
- Page 4 Try to choose a point in the circuit that never gets empty of water, because the probe deteriorates very quickly when dry. ELECTRICAL INSTALATION Power supply Connect the 230 VAC power supply cable plug (3) into a mains power point provided with a protective earthing conductor (PE) pH Basic...
- Page 5 For example, in the case of the figure, if pH is at 8, the pump will dose al 40%. - When the pH is above the upper setpoint, the pump will dose to the fixed volume defined for the upper point. In the case of the figure, 80%. pH Basic Ver 05/19...
- Page 6 Enter the sub-menu 2 Cal pH4 by pressing OK key, it will show the following screen: pH 4 Calibration pH 7 Calibration Lec: 4.05 4.00 Lec: 7.05 7.00 The value next to Lec (on the left) indicates the current pH value measured by the probe. pH Basic...
- Page 7 Press OK to enter the sub menu 5 Factory calib, it will show the following screen. Factory Calib.? yes:OK exit:MENU pH Basic Ver 05/19...
- Page 8 Press OK to enter. Scroll with arrow keys and choose the contrast level. Then press TECHNICAL DATA Power supply 100-240 VAC 50-60 Hz Consumption 12 W Pump Flow rate 1.5 l/h Maximum pressure 1.5 bar Dimensions (mm) 220 x 130 x 85 pH Basic...
- Page 9 Basic Ver 05/19...