Switching On The Device - ELZAB Care SP1 UV-C User Manual

Switching on the device

Do not switch on the device if it is kept in storage or transported at
low temperatures! Before switching on, the device should have
room temperature .
EN
Do not switch on the device with mechanical or electrical damages!
carefully unpack the device by removing the individual elements
1
of the package
put the device in a safe place (without direct access of children,
2
protection against mechanical damages and overturning)
connect the power cable to the device
3
accessed after dismantling the lower filter cassette, points 1 - 3
in lower filter replacement, Fig. 2).
connect the power cable to the power source
4
Connect the device to a 3-wire installation of the main power
supply: a socket with a protection pole (PE)!
switch the device on with the switch on the upper cover (Fig. 1)
5
When the flowing air does not generate noise, make sure that the plug
of the power cord is correctly set in the device.
Replacement of operational parts
Switch off the device with a switch and disconnect the power cord
from the mains before replacement of each operational part!
For the proper, safe and efficient operation of the device, solely
consumables recommended by the producer should be used.
Wearing parts are available from the producer of the device.
Due to harmful UV-C ultraviolet radiation, never switch on the device
without its enclosure or with removed or damaged air filters!
2
(the socket may be
care.elzab.p
l