EINHELL BMS 800 Operating Instructions Manual page 7

Anleitung BMS 800
Drilling bit stop
Caution:
For safety reasons always use the
additional grip when working. As the
noise level exceeds 58 dB (A)
during operation it is recommended
to wear an ear protection.
06.11.2001 8:48 Uhr
Hammer drill
Drilling/screwing
On/off switch
Switching
on:
Continuous:
operation:
Switching
off:
Select the correct speed for any type
of work (for example, driving screws,
drilling, etc.) by firmly pressing on the
operating switch (A).
Seite 7
Press operating
switch A
Secure switch A
with lock button B
Press operating switch
A for short period.
Caution:
The bits should be tightened on
all three holes in the chuck.
After tightening remove the key
for the chuck.
Caution:
Only switch at standstill. When
drilling in tiles and stove tiles
set to position drill/screw.
Clockwise rotation Anti-clockwise operation
Turning the speed control to the right
increases the revolution
Position 2
Caution:
Only switch over from position 1 to
position 2 when machin e is not
running.
GB
7