Table of Contents
Advertisement
GPON Repeater Operation Manual
Chapter 3 Hardware Installation
Chapter 3 Hardware Installation
3.1. Packing Inspection
Before installing BD-2GPON-OEO, please make sure that the following items are contained in the
packing box: a BD-2GPON-OEO amplifier, a DC48V power cord or a 220V to 12V power adapter
and a manual.
3.2. Jumper
Use single mode SC fiber optic jumpers.
3.3. Front Panel Connection Diagram
Uplink to OLT
Connect to ONU
Figure 0-1 Front Panel Connection Diagram
3.4. DC Power Cord Connection
The DC48V power cord is as shown in the figure below. One end is a green phoenix terminal
connector which is used to connect BD-2GPON-OEO device. The other end is two power cable
connectors which are used to connect the DC power supply. As shown in the figure below, the power
cable marked "RTN" is used to connect the DC positive pole and the power cable marked "N48V" is
used to connect the DC negative pole.
Please do not plug the electrified power cord.
Copyright © 2018 Shanghai Baudcom Communication Device Co.,Ltd.
All Rights Reserved.
10 / 18
Advertisement
Table of Contents
