This supplemental manual has been provided to walk you through the safe and efficient installation of Trus-T-Lift Landing Devices. Please read this manual, as well as the main installation manual, thoroughly before installing and operating your lift. We recommend your lift and any add-ons be installed and serviced by a qualified technician.
The lift is intended for use by people and not to be used for cargo or other purposes. Lifting capacity is up to a maximum of 750 lb. unless otherwise noted on the lift and in RAM’s supplied documentation. (DO NOT OVERLOAD THE LIFT). Overloading the lift will render RAM’s warranty null and void.
Section 3: Upper Landing Gate Upper Landing Gate Frame Spring Hinge 4”x4” Angle Interlock & Bracket Door Panel RAM Elevators + Lifts 1-800-563-4382...
Page 7
Note These procedures are not the only method for installing an upper landing gate, just the recommended procedure from RAM. 1) Mount the gate to your landing using one of two ways: a. Drill through the 4”x4” angle on the bottom of the door...
Not doing so can damage the unit, and lead to injury and/or death. Section 5: Remote Call Station A Trus-T-Lift Remote Call Station can be used to call the carriage to the landing, or also send the carriage to an alternate landing when using a remote call/send.
Once the interlock and the interlock tab have been mounted, wire the interlock into the lift as per the provided electrical schematics and wire diagrams using protective conduit as per the applicable electrical codes. 1-800-563-4382 RAM Elevators + Lifts...
Need help?
Do you have a question about the TRUS-T-LIFT and is the answer not in the manual?
Questions and answers