Wall Mount Installation; Shower Head Installation; Hose Installation - Price Pfister 16 Series Manual

7
7B
7D
A
UNEVEN SURFACE
7F
7E
B
7G
7C
7E
7D
7J
7A
SMOOTH SURFACE
7C
7E
C
7D
7C
7H
ENGLISH

7 WALL MOUNT INSTALLATION

Vertically align Wall Mount (7A) below Shower Arm (7B) and place in a desired location.
SMOOTH SURFACE: Attach Suction Cup (7C) by pressing it against wall surface
allowing it to compress. Tighten Post (7D) onto Suction Cup (7C) by turning it clockwise
until it is properly positioned and fixed firmly to the wall.
UNEVEN SURFACE: In case Wall Mount falls next to a tile grout line, or the wall surface
is not smooth, use Adhesive Backing (7E).
A
. Remove Protective Seal (7F) from Adhesive Backing (7E) and firmly attach it to the
wall surface. Allow drying for 12 hours.
B
. Remove the Clear Seal (7G) from Adhesive Backing (7E). Firmly attach Suction
Cup (7C) to Adhesive Backing (7E).
C
. Thread in Support Post (7D) to Suction Cup (7C).
Connect Post (7D) into Wall Mount Shell (7J) and secure by screwing Fastener (7H).
8
8A

8 SHOWER HEAD INSTALLATION

Thread Shower Head (8A) onto Shower Diverter (8B). Make sure Rubber Seal (8C) is
retained inside Shower Nut (8D).
Make sure Shower Head (8A) is securely tightened to Shower Diverter (8B).
9

9 HOSE INSTALLATION

Place Rubber Seal (9A) inside Ribbed Hose Fitting (9B). Connect Hose (9C) onto the
bottom end of Slide Bar (9D) by turning Ribbed Hose Fitting (9B) clockwise.
3
8B
8C
8D
9D
9A
9B
9C