Advertisement
7
STEP 7. Take the 10 male slide components (M) and
slide 5 onto the female slides on the left of the draw
compartment and 5 onto the female slides on the
right hand side of the draw compartment. Push them
fully in to engage them, then pull them out to the stop
9
point.
Diagram 9. Orientate each slide as shown in the diagram above with the rear hook pointing
towards the rear of the draw or the rear of the cabinet. Put the rear hook on each slide into the
square hole nearest the back of the draw or the back of the cabinet and push the slide backwards
to engage the hook. Swivel the front of the slide up or down slightly until the other two hooks
appear in the other two holes. Keep the rear face of the slide up against the draw or slide panel.
On the draws pull the slide sharply upwards to engage it. On the cabinet push the slides down to
engage.
8
STEP 8. Attach a left hand female slide (K) to left
hand side of each draw and a right hand female
slide (K) to the right hand side of each draw (see
diagram 9). Engage each draw onto the protruding
male slides and push fully home, then open the
draw to check that it is retained.
AP2050 - 1 - 101005
Advertisement
