Advertisement
3.
ASSEMBLY
1
STEP 1. Take two crossrails (B) and bolt them
to the cabinet sides (A) using 8 bolts (O), 8 lock
washers (P), and 8 nuts (Q). Ensure that the
pairs of holes that accept the corner braces are
facing downwards. (Refer to STEP 5.)
4
STEP 4. Take two crossrails (B) and bolt them
to the cabinet sides (A) using 8 bolts (O), 8 lock
washers (P), and 8 nuts (Q).
2
STEP 2. Bolt 1 left & 1 right slide panels (D) &
(E) into position, only bolt at front of Work
Bench using 4 bolts (O), 4 lock washers (P),
and 4 nuts (Q). Fix 5 left hand female slide (L),
onto each slide panel (D) and 5 right hand
female slide (L), onto each slide panel (E)
5
Refer to Diagram 9 on how to fit slides.
STEP 5. Screw in the four adjustable leg
levellers (R). Bolt the four corner braces (I) into
position using 16 bolts (O), 16 lock washers
(P), and 16 nuts (Q)
3
STEP 3. Take two draw stops (G) and back
panel (F) and bolt them to the back of the
cabinet with the draw stops between the panel
and the cabinet. Use 4 bolts (O), 4 lock
washers (P), and 4 nuts (Q).
6
STEP 6. Place the wooden top (N) face down
on a flat, clean, smooth surface. Position the
cabinet upside down on the wooden top and
mark the hole locations on the top. Move the
cabinet to one side and drill 5/32” diameter x
1/2” deep holes in the top. DO NOT DRILL
DEEPER THAN 1/2”. Attach frame to top with
the 4 hex head screws (S).
AP2050 - 1 - 101005
Advertisement
