DSE DSE4200 Quick-Manual For Use And Start Up

DSE4200 Quick-guide for use and start up
Congratulations with your microwave-based moisture meter for balers, The DSE4200.
This guide is intended as a simple and straightforward guide how to get started using the DSE4200 with a few steps
after installing it.
If your moisture meter is installed and prepared by
the dealer, you can always go through the menu
under the different menu items and change settings
or repeat e.g. Zero Adjustment.
To start the menu, hold down the right-hand button
for 3 seconds. Another option is to press "Restore
factory settings", which will bring you through all
the settings shown in this Quick Guide.
Step 2. First time use
Select Ok or Skip using the buttons below the
display screen.
Quickguide UK Version 1.00.00
Step 1. System Check
When power is applied to the display for the first
time, the unit will perform a "system check" and try
to contact the RX and TX units.
If successful, the system will automatically proceed
to the "First time use" dialog. If this fails, there are
faults and shortcomings in the cabling. See user
manual.
Step 3. Language
Select language by using the up/down arrow keys.
Final selection is made with the arrow pointing to
the right. To get to the next point, press the "Door
button".