Drain Shower Pan And Clean Strainer; Wash Exterior. Polish, Wash, And Lubricate Metal Deck Hardware; Wash And Wax Spars. Lubricate Winches And Sheaves. Inspect For Any Damage; Clean Standing Rigging And Inspect For Damage - Tayana 37 Operation & Maintenance Manual

7. Drain shower pan and clean strainer.

8. Wash exterior. Polish, wash, and lubricate metal deck hardware.

9. Wash and wax spars. Lubricate winches and sheaves. Inspect for any damage.

10. Clean standing rigging and inspect for damage.

11. Review manuals for all optional equipment.

Follow any winterizing procedures given. Generators, air-conditioning systems, and some
refrigeration systems are among those systems which require winterizing.

12. If boat is hauled, clean and inspect bottom thoroughly...

Pay particular attention to signs of structural damage to glass, rudder operation, gudgeon
weldment and fasteners, electronic senders, thru-hulls, propeller, and zincs.
CAUTION: Be certain that the prop shaft coupling is disconnected prior to hauling the
yacht, and follow hauling instructions in this manual.

13. It is a good practice to record items...

that were given attention and any defects found during decommissioning. This list will be
valuable to you when recommissioning in the spring.

14. You may wish to use deck covers...

and/or various devices available to prevent ice formation around a yacht stored in the water.
These will provide additional protection to the yacht during the winter months. Consult your local
marina for further information and sources of this equipment.
D. RECOMMISSIONING AFTER LAY-UP
Recommissioning after lay-up is somewhat less involved than the initial
commissioning. The following steps are suggested:
III-15