Siemens SIREMOBIL Iso-C Service Instructions Manual page 10

10
•
Reattach the plate (1/Fig.17) with the screws.
•
Clean the braking surface of the horizontal brake (2/Fig.17). (Dirt and metal particles)
•
Reattach the horizontal brake.
•
Switch ON the Siremobil and release the horizontal brake.
•
Insert the horizontal carriage back in the bearing support.
•
Note the following:
- Be careful not to crimp or damage the cables.
- Be careful of the horizontal brake cable. Refer to Fig.18 and 19.
- The C-arm must remain centered on the work table. Move the work table, if necessary.
- Secure the cover with the switches to prevent it from falling.
- When inserting the horizontal carriage, keep it centered to the ball bearings.
- You may have to adjust the position of the vertical lifting column until the horizontal
carriage moves easily.
SIREMOBIL Iso-C
Replacing the horizontal lift brake
SPR2-230.076.01
Rev. 01 02/99
Page 10 of 16
TD SD 24 Medical Engineering
Siemens AG