Elevator Mode - Phase Technology Phase Perfect PT007 Operation & Installation Manual

Switches now act as toggles to make selection.
YES (enable transformer mode)
NO (disable transformer mode)
Leave Transformer select menu at desired setting, after 3 seconds of no switch toggling,
the setting will be saved. Switches must be returned to the OFF or position after
changes are complete. Turn power to the PT OFF again. Uninstall SW3 and SW4, re-
install the jumper wire connecting AUX1 and COM, and re-apply power to converter.
WARNING! Make sure the input power disconnect switch is in the OFF position
before opening the front cover to the unit. Opening the front cover with the switch in the ON
position exposes the user to the risk of electric shock.
WARNING: Risk of electric shock. Disconnect all incoming sources of power and wait
30 minutes before opening the front cover to perform the following task.

Elevator Mode

Elevator Mode forces T3 to maintain voltage during heavy startups. This setting should
only be used if elevator is tripping due to a drop in input voltage. To enable Elevator Mode,
follow the steps below:
Step
1
2 Remove jumper wire between AUX1 and COM
Connect a dry contact switch between AUX3
3
Connect a dry contact switch between AUX4
4
5
6
7
Switches now act as toggles to make selection.
Select Option
YES (enable elevator mode)
NO (disable elevator mode)
Leave Elevator select menu at desired setting, after 3 seconds of no switch toggling, the
setting will be saved. Switches must be returned to the OFF position after changes are
complete. Turn power to the PT OFF again. Uninstall SW3 and SW4, re-install the jumper
wire connecting AUX1 and COM, and re-apply power to converter.
WARNING! Make sure the input power disconnect switch is in the OFF position
before opening the front cover to the unit. Opening the front cover with the switch in the ON
position exposes the user to the risk of electric shock.
Select Option
Directions
Turn power to PT OFF
and COM (now called SW3)
and COM (now called SW4)
Turn power to the PT ON
SW4: ON, OFF
SW3: ON, OFF, ON, OFF
Directions
SW4: ON, OFF
SW3: OFF
Display Reading After Step
CONFIGURATIONS ELEVATOR
Directions
SW4: ON, OFF
SW3: OFF
V2.0
-
-
-
-
-
2/3
ELEVATOR SEL
24 | Page