Hapton Bay 52-COPY Use And Care Manual page 11

Assembly - Hanging the Fan (continued)
4
Wrapping the extra wire
NOTE: Follow this step ONLY if you did not cut the extra
length off from the wires coming from the ceiling fan.
□
Gently wrap the excess wire around the mounting bracket.
□
Secure with electrical tape.
5
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
□
Align the locking slots of canopy (C) with the two screws (GG)
and alignment post (QQ) in the mounting bracket (A).
□
Push up the canopy (C) and turn clockwise until the alignment
post (QQ) engages the round hole and the screws (GG) engage
to the key slots.
□
Firmly tighten the two mounting screws (GG).
□
Install the decorative bottom cover (HH) by aligning the covers
slots with screws in the bottom of the canopy (C). Rotate the
bottom cover clockwise to lock in place.
10
QQ
A
GG
C
B
HH
D