Paper Specification; Interface Specification - Casio UP-370 Service Manual

1111

PAPER SPECIFICATION

Paper Width
Paper Roll Size
Specified Paper
Paper Roll Spool Diameter
NOTE: The end of the paper roll must be free to come off the spool when finished. It must not be
adhesively attached or attached in another semi-permanent manner.
1111

INTERFACE SPECIFICATION

111111 RS1111C SPECIFICATION
Data Transmission
Synchronization
Handshaking
Signal Levels
Baud Rate
Data Word Length
Parity Settings
Stop Bits
Connector (Printer Side)
* The data word length, baud rate, and parity depend on the DIP switch settings.
(Refer to "5. THE DIP SWITCHES".)
111111 RS1111C INTERFACE CONNECTION EXAMPLE
HOST SIDE
(DTE ex.8251)
TxD
RxD
DTR
DSR
RTS
CTS
GND
79.5 ±0.5 mm (3.13 ±0.02")
Roll diameter: Maximum 80 mm (3.15")
Take-up paper roll width: 80 +0.5/-1.0 mm (3.15 +0.02/-0.04")
Specified thermal roll paper: NTP080-80
[Paper: TF50KS-E2D Nippon Paper Industries Co., Ltd.]
Packaged roll paper:
[Paper: PD160R-N (Oji Paper Mfg. Co., Ltd.)]
The following paper can be used instead of the paper above:
Paper: HP220AB1 (Mitsubishi Paper Mills Ltd.)
Inside 12 mm (0.47")
Outside 18 mm (0.71")
Serial. EIA RS-232C compliant
Asynchronous
DTR/DSR or XON/XOFF control *
MARK = -3 to -15 V:
SPACE = +3 to +15 V: Logic "0"/ON
4800, 9600, 19200, 38400 bps *
8 bits, 7 bits *
None, even, odd *
1 or more
Male DSUB-9 pin connector
PRINTER SIDE
(Pin No.)
RxD (2)
TxD (3)
DSR (6)
DTR (4)
GND (5)
– 2 –
Logic "1"/OFF